

Data sheet
Turn on Simon using his foot switch. Then press and hold the on/off button on the remote for 5 seconds until you hear a beep. This indicates that the connection was successful and you can now control Simon using his remote control.
In this video we explain the procedure step by step.
How to clean Simon's fabric cover?
To clean the fabric cover, start by detaching Simon's fan housing from the mast. You can now remove the 4 screws on the back of Simon that hold the air inlet grill in place and the single screw underneath for the air outlet grill. There are small openings in the fabric cover that are used to fit it to the front and back of the housing. All these openings must be free.
The textile cover can be washed at 30° C on a gentle wash cycle. The cover must be completely dry before being put back on the device.
When putting the textile cover back on, make sure that the hole for the pole is in the right place. If it is, you can put the textile cover back on the Simon fan housing. Make sure all the holes are aligned on the front and back of the case. Finally, replace the two grilles (air inlet/outlet) and tighten the 5 screws.
In this video, we show you from second 44 how to remove and replace the textile cover.
You might also like