Humidifier SOLNAN Black

If your humidifier is scaled, we simply recommend using white vinegar and water. Dilute the vinegar in 50% to 60% water, leave for 10 to 20 minutes and rinse. Be careful not to rinse with too much water, as this could introduce water into the electronic part (which would damage your device). You can also use specialized products, such as Cleaner&Descaler from Stadler Form.

With an ultrasonic humidifier, the steam is diffused into the room by means of a small fan whose air inlet is, in most cases, located under the device. It is therefore necessary to check that nothing is blocking this air inlet. For example, avoid placing the device on a carpet, rug or cloth. In addition, be sure to check the temperature of the room: if it is too cold, the steam from your humidifier will fall around the device. It is therefore necessary to move it closer to a heat source or place it a little higher. Finally, we advise you to lower the power of the steam.

This is a normal safety feature on this type of appliance. After replacing the tank, simply press the ON/OFF button. The appliance will resume operation automatically.

Yes, the base of your device is made of polypropylene (like an essential oil diffuser). You can therefore, without fear, put drops of oils directly into the water in the tank.

A humidifier is considered "top-fill" when its user manual indicates that you can fill it from the top. This way, you don't have to remove and carry the tank to fill it: a bottle of water is enough and this greatly simplifies the daily use of the humidifier. In the case of a "top-fill" humidifier, the tank is shaped like a bucket with a handle.

Frequent use of a humidifier requires regular and careful maintenance, at least once a week if you use it very often.

To clean it, use white vinegar: in addition to being economical, it is the ideal product for eliminating limescale. There are also specific maintenance products, such as the Stadler Form cleaner and descaler Cleaner&Descaler which effectively preserves materials.

We recommend filling the tank with vinegar and water, then leaving it to act for 30 minutes before rinsing it. Just be sure to unplug it first and not wet the electronic components so as not to damage them and put yourself in danger.

In the case of an ultrasonic humidifier, clean the metal plate with a soft brush.

Finally, do not let water stagnate for more than 72 hours in the device to avoid any proliferation of bacteria.

You must reset your product: First, remove the water tank and dry the base of the device thoroughly. The following operation must be performed within 1 minute after the device is turned on:

1. Connect the power supply.
2. In standby mode, press the ON-OFF button 3 times and then press the button for 3 seconds.
3. The display shows “PL”, then “PA”, which means the setting is successful. If “EE” is displayed, it means that the adjustment has failed and the operation described above must be repeated.

Caution: Do not disconnect the power supply during the adjustment process: the power must not be cut off until "PA" is displayed.

It is possible to replace the used diffusion cotton with a piece of makeup remover cotton that you have previously cut out yourself.