

Free delivery from 30€
With our partner Crédit Agricole
Guarantee 2 years, AS internal
Customer Service : dial +33 9 72 232 232
Are you looking for a device that can humidify, purify and scent your home at the same time? The ROBERT Silver air washer is the 3-in-1 solution you need! It combines design and high technology for even more performance.
Data sheet
If your humidifier is leaking, it may be because:
Be careful, do not try to fill your humidifier from the top, unless it is a "top-fill" humidifier and this is specified in the instructions. Please note that it is normal for there to be a little water in the base of the tank, at the level of the ultrasonic plate.
Clean the water base, evaporation discs and water tank thoroughly every 2 weeks. Use warm water and a soft brush or sponge. If limescale deposits appear in the water base or water tank, use the descaling solution Cleaner&Descaler diluted with water. To do this, remove the tank and the Water Cube. Remove the water tray and discs. Dispose of any remaining water in the tray and fill it with tap water. Add the same amount of Cleaner & Descaler descaling solution. Replace the discs and water tray. Activate the device's cleaning mode (« clean mode »). The cleaning cycle lasts 20 minutes and the device stops automatically.
This means that the desired humidity level has been reached and the unit has automatically switched off.
The humidity level is measured approximately every 30 minutes - the fan runs for 1 to 2 minutes -. If the humidity level falls below the set value, the unit starts humidifying again.
Press the 'Air Humidity' button to set the desired humidity level again. You can now select the desired level by pressing the 'Air Humidity' button several times (the display will flash while the settings are being adjusted). The selected value is saved if no further adjustment is made for approximately 10 seconds. The display will again show the humidity level of the room. Once the humidity level is reached, the unit will switch off again and the display will flash.
Please check that the water tray and especially the evaporation discs are properly inserted into the appliance. The water tray must be gently inserted until you hear a «click».
Yes, the air washer will automatically turn back on in the event of a power outage.
Models with a production date before 2015 are not equipped with this. Make sure the air inlet and outlet are cleaned regularly (using a dry brush or vacuum cleaner) to prevent dust build-up.
It may happen that the discs become loose during operation or after cleaning. As a result, the gear wheel on the discs no longer holds properly. To tighten the discs, turn the first disc with the gear wheel clockwise.
Yes.
The intensity of the scent depends on 3 factors:
Add a few more drops of essential oil to increase the intensity of the fragrance. It should also be taken into account that the main functions of the air washer are to purify and humidify the air. The intensity of the fragrance will therefore never be comparable to that of a fragrance diffuser.
Yes, they are reused during the next startup.
You might also like